home *** CD-ROM | disk | FTP | other *** search
- Hi Alexei,
-
- In a message of 25 Jan 96 you wrote to All:
-
- AC> I've just installed CyberVision 64/4Mb on my system and board won't
- AC> work! The system are:
-
- AC> A4000, CyberStorm 060, 16 Mb RAM, CyberSCSI, FlickerFixer AGA, Buster
- AC> Rev.11, DOS 3.1, Monitor Commodore 1940
-
- AC> I can see CV64 with ShowConfig command but CyberVision does not appear
- AC> in ScreenMode requester. All suggested files are copied properly like in
- AC> installation instruction. If I try open CyberWindow or CyberView they
- AC> say that Cybergraphics.library cannot be open - that's very strange
- AC> 'cause library is in Libs: directory and version is OK! Other libraries
-
- The one very important file you don't mention is the monitor driver. Does
- "Cybervision" reside in devs/monitors?
-
- Does ENVARC: (and ENV:) contain something like the following?
-
- CyberVision (dir, contains monitor prefs file)*
- ALERTEMU (env var)
- BOOTLOGO (env var)
- CPUP2C (env var)
- CyberVisionMonitor (env var, defines which monitor prefs file to use)*
- HIDE15BIT (env var)
- HIRESCRSR (env var)
- KEEPAMIGAVIDEO (env var)
- NOCHIPSCREEN (env var)
- NOPASSTHROUGH (env var)
- PLANES2FAST (env var)
-
- * If your A1940 is anything like my old A1960, you'll be using either the
- 31KHz or 38KHz monitor prefs files.
-
- Regards,
-
- Mark
-
- ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
- mpa@wvision.iig.com.au Cairns
- Wishful Vision Australia
-
-